v24.1 – BARAM Portal

24.1.3

Parallel configuration dialog hung if number of processors were not changed and Apply button was clicked
Monitoring for a point that is not snapped on a surface is now working in multi-region case
“saveAs” for Parallel-configured project is now working

“Export” succeeded only when boundary layers were inserted and baramMesh run in parallel configuration

User Parameters can be defined and used for configuration
Mesh information such as bounding box dimension, number of cells, and min/max cell volumes
Density-base solver with far-field Riemann boundary condition for high Mach number external flow
Batch processing: Users can setup User Parameters in combination and run them in sequence
Multi-region case can be set up by importing separated multiple polyMesh which might be generated by other meshing tools
Flow direction can be configured based on Angle of Attack(AoA) and Angle of Sideslip(AoS)

Wall function for Realizable k-e with enhanced wall treatment model has updated
The concept of “Modified Pressure” has been deprecated. The solver now automatically applies pressure adjustments based on the selected solver type.
Users can transfer steady-state calculation results as initial conditions for transient simulations.
Units are now explicitly shown for cell zone source terms
A pop-up window notifies users when the solver finishes its calculations
Certain boundary condition types are inferred from mesh boundary names and geometric types
Users can adjust the maximum Courant number for multi-phase steady simulations
NF24.1.5 is used as internal solver

Maximum surface refinement level can be configured. It was a fixed value of minimum plus one
Spaces in geometry names are automaticall replaced with underscore(‘_’)
Users can now configure region steps to include solid regions only ( no fluid region )
Fixed width font is used in console window

Prevented loading of multi-region meshes inappropriately for multi-phase projects

Fixed a bug where castellation failed when a sphere was within a HEX6 bounding box

Monitoring for a point that is not snapped on a surface is not working in multi-region case
“saveAs” for Parallel-configured project is not working

“Export” succeeds only when boundary layers are inserted and baramMesh runs in parallel configuration